Play the "Jingle Bells" or the "Mission Impossible" tune using one digital output of the Arduino, connected to a little speaker. Because it's almost Christmas, i thought it was a good time to turn an ...

Play the "Jingle Bells" or the "Mission Impossible" tune using one digital output of the Arduino, connected to a little speaker. Because it's almost Christmas, i thought it was a good time to turn an ...

Arduino code to play Jingle Bells Using the Arduino, plug the positive pin into slot 8. Run in series a 220 OHM resistor and a Passive Piez Buzzer. Connect to ground.

The Processing GUI sends a character, depending on which button you press, through serial to the Arduino program. 'F' for Fur Elise and 'J' for Jingle bells. The "songs", if we can call them that, are ...

Put aside all of the projects that use an Arduino to blink a few LEDs or drive one servo motor. [IngGaro]’s latest project uses the full range of features available in this versatile microcontroller ...

This proposed Arduino-based automatic bell device is an electronic system that rings bells at predefined times without manual intervention. It is built around an Arduino Uno, which is programmed to ...

The folks over at [Soup], a British marketing agency, thought up this cool project. It’s a set of handbells hooked up to an Arduino, actuated by central locking motors found in car doors. By the look ...